e-STUDIO350/450 OUTLINE OF THE MACHINE 2 - 22 November 2003 © TOSHIBA TEC
2
2.4.2 Construction of boards
(a) Construction diagram of boards
This system consists of the following including the SYS board as a main board.
:
DC power supply line
:
AC power supply line
:
Signal line
AC input
Main switch
Cover opening/closing
interlock switch
SYS
PS-ACC
FIL
or
FUS
LGC
CCD
INV
SLG
Scanner unit
KEY
DSP
Control panel
NIC
ADU
SFB
HVT
IH
LDR
LRL
SNS
Laser unit
(b) Function of each board
CCD board:
This is the board to convert the reflected light by the original to electrical signals. It consists of the
CCD, and its peripheral circuitry. The CCD converts the reflected light by the original to analog signal
and outputs it to the SLG board.
SLG board:
This is the board to mainly control the scanning function (scanner unit) and consists of the Scanner-
CPU, ASIC, memory (Flash ROM and SRAM), A/D converter, driver for motor drive, etc. When
scanning the original, the exposure lamp and scan motor are driven by the command from the
Scanner-CPU. The analog signal output from the CCD board is then converted to digital signal by
the A/D converter. Image processing is performed by ASIC.
INV board:
This is the board on which the lighting control circuit of the exposure lamp is mounted. The exposure
lamp lights by the command from the Scanner-CPU.
DSP board:
This is the board to mainly control the control panel. The panel processing CPU detecting the input
from each button and touch panel, and the lighting control circuit for the backlight of the LCD are
mounted. And it relays the control signal of the control panel from the SYS board to the LCD and KEY
board.
Fig. 2-402
To Next Page
Loading...
