Toshiba e-Studio477s - Select the Same Size Button Under COPY

- 66 -
How to Load the Paper
1
2
4
5
6
3
Note
•
Do not mix papers of different size, type, or
thickness.
•
When adding paper to the bypass tray, take out any
paper already inserted, then add the extra paper and
realign the paper into a tidy stack.
•
Curled or warped postcards or envelopes may cause
misfeeds. Try to use material that is not curled. Any
curl of 2 mm or more should be corrected.
•
Do not place any material on the bypass tray other
than paper for printing. Do not use excessive force
when raising or pushing the bypass tray.
8
Select the same size button under
“COPY” as that of the paper you
placed on the bypass tray.
The paper size is now set.
Note
•
If the paper size is not selected in this step, copying
may be slowed down.
9
Press [PAPER TYPE] on the touch
panel if the paper type of the paper
you placed on the bypass tray is
other than plain paper.
10
Press the button of the same paper
type as the paper you placed on the
bypass tray. Then press [OK].
Note
•
If you select a wrong paper type, this could cause a
paper misfeed or signicant image trouble.
•
When you select a paper type, you can conrm it
with the icons displayed on the equipment status
indication area as shown below.