54 Faxing Problems
0.Faxing Problems
Error codes
To learn the meanings of the error codes described in the lists or reports, see the following section:
P.64 “Error codes on transmission and reception”
Error messages
Below is a list of error messages that might appear on the touch panel. When any message in the list appears on the
touch panel, press [FUNCTION CLEAR] on the control panel to clear it, and then take action suggested in the
“Remedy” column.
Never attempt to repair, disassemble or modify the equipment by yourself.
You could cause a fire or get an electric shock. Always contact your service representative for maintenance or repair of
the internal parts of the equipment.
Message Cause Remedy
Memory overflow Memory overflowed when scanning
documents to the memory.
Either wait for memory to be cleared, or check
the jobs and delete reserved jobs on the [Job
Status] screen.
Communication error Communication error occurred during
direct TX.
Retry communications.
Job reservation full The number of reserved jobs exceeded the
maximum.
Either wait for job reservations to be
completed, or check the jobs and delete
reserved jobs on the [Job Status] screen.
Job memory full The total number of destinations for
reserved jobs exceeded the maximum.
Either wait for job reservations to be
completed, or check the jobs and delete
reserved jobs on the [Job Status] screen.
Sorry not possible On-hook or direct TX was attempted
during communications.
Wait for communications to end and retry
communications.
Not allowed now Further polling transmission reservation
was attempted even though polling
transmission was already reserved.
Either wait for polling transmission jobs to be
completed, or check the jobs and delete
reserved jobs on the [Job Status] screen.
Too Many Tel # Digits 128 digits or more were registered for a
chain dial communication.
Confirm the number of digits dialed and
register the numbers again.
Fax line1 is out of
order./Fax line2 is out
of order.
An error occurred with the Fax unit. Turn the power OFF and then back ON. If the
error still persists, contact your service
representative.
To Next Page
Loading...
Need help?
General
