8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 41
[E030] Power-ON jam
Relation between the jamming area and the corresponding sensors and covers
Check item Measures
Fuser transport sensor • Sensor check (Perform the input check: 03-[FAX]OFF/[7]/[C])
• Connector check
• Harness check.
LGC board • Connector check (CN332, CN335)
• Board check.
Fuser • Connector check
• Harness check.
Drive unit, Rollers • Gear check
• Roller check
Reverse motor
• Motor check (Perform the output check:03-126)
• Harness check.
Replace parts Remarks
Fuser transport sensor
Reverse motor
LGC board
Classification Error item
Other paper jam Paper is remaining on the paper transport path of the equipment when the
power is turned ON
Check item Measures
Cover, Transport pass • Open the cover of the unit/area whose picture is flashing on the control
panel and remove if there is any paper on the transport path. (Refer to
the table below.)
Each sensor • Sensor check (Refer to the following table.)
• Connector check
• Harness check.
LGC board • Connector check
• Board check.
Drive unit, Rollers • Gear check
• Roller check
Jamming area Sensor Test mode / Input check
Registration area Registration sensor 03-[FAX]ON/[4]/[E]
Exit/Reverse area Exit sensor 03-[FAX]OFF/[7]/[B]
Reverse sensor-1 03-[FAX]OFF/[7]/[E]
Reverse sensor-2 03-[FAX]OFF/[7]/[D]
Fuser transport sensor 03-[FAX]OFF/[7]/[C]
To Next Page
Loading...
