e-STUDIO556/656/756/856/557/657/757/857 © 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 42
[E061] Incorrect paper size setting for 1st drawer
[E062] Incorrect paper size setting for 2nd drawer
[E063] Incorrect paper size setting for 3rd drawer
[E064] Incorrect paper size setting for 4th drawer
[E065] Incorrect paper size setting for bypass tray
Reverse transport area Horizontal transport sensor-1 03-[FAX]OFF/[9]/[F]
Horizontal transport sensor-2 03-[FAX]OFF/[9]/[G]
Horizontal transport sensor-3 03-[FAX]OFF/[9]/[H]
Paper feeding area 1st drawer feed sensor 03-[FAX]OFF/[1]/[D]
2nd drawer feed sensor 03-[FAX]OFF/[2]/[D]
3rd drawer / tandem LCF feed sensor 03-[FAX]OFF/[3]/[D]
4th drawer feed sensor 03-[FAX]OFF/[4]/[D]
1st drawer transport sensor 03-[FAX]OFF/[1]/[C]
2nd drawer transport sensor 03-[FAX]OFF/[2]/[C]
3rd drawer / tandem LCF transport sensor 03-[FAX]OFF/[3]/[C]
4th drawer transport sensor 03-[FAX]OFF/[4]/[C]
Intermediate transport sensor 03-[FAX]OFF/[1]/[A]
Replace parts Remarks
Each sensor
LGC board
Classification Error item
Other paper jam The size of paper in the 1st drawer differs from size setting of the
equipment.(E061)
The size of paper in the 2nd drawer differs from size setting of the
equipment.(E062)
The size of paper in the 3rd drawer differs from size setting of the
equipment.(E063)
The size of paper in the 4th drawer differs from size setting of the
equipment.(E064)
The size of paper in the bypass tray differs from size setting of the
equipment.(E065)
Check item Measures
Setting • If any paper remains in the equipment or drawer, remove it. Match the
paper size of the drawer setting and the one in the drawer.
• Paper size detection is performed at the first sheet of paper when the
drawer is opened or closed, or when the power of the equipment is
turned ON.
Replace parts Remarks
Jamming area Sensor Test mode / Input check
To Next Page
Loading...
