Toshiba e-STUDIO557 - Page 45

e-STUDIO556/656/756/856/557/657/757/857 © 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 44
[E0A0]Image transport ready time-out jam
[E200] 1st drawer transport jam (paper not reaching registration sensor)
[E210] 2nd drawer transport jam (paper not reaching registration sensor)
[E300] 3rd drawer transport jam (paper not reaching registration sensor)
[E330] 4th drawer transport jam (paper not reaching registration sensor)
[E3C0] Tandem LCF transport jam (paper not reaching registration sensor)
HDD
SYS board
LGC board
PLG board
Classification Error item
Other paper jam Image data to be printed cannot be sent.
Check item Measures
Other • Remove the paper remained in front of the registration sensor.
• If the error still occurs, check the following.
Power • Check if the error is cleared by turning the power OFF and then back
ON.
SYS board • Connector check
• Page memory check
• Board check.
LGC board • Connector check
• Harness check.
• Board check.
HDD
• Harness check.
Replace parts Remarks
Page memory
HDD
SYS board
LGC board
Classification Error item
Paper transport jam Paper not reaching registration sensor
Check item Measures
Registration sensor (S18) • Sensor check (Perform the input check: 03-[FAX]ON/[4]/[E])
• Connector check
• Harness check.
Intermediate transport sensor
(S17)
• Sensor check (Perform the input check: 03-[FAX]OFF/[1]/[A])
• Connector check
• Harness check.
Replace parts Remarks