Toshiba e-STUDIO557 - Page 52

8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 51
[E360] 4th drawer transport jam (paper not reaching 3rd drawer / Tandem LCF transport sensor)
[E510] Transport jam during duplex printing (paper not reaching reverse sensor-2)
Classification Error item
Paper transport jam Paper not reaching 3rd drawer / Tandem LCF transport sensor
Check item Measures
3rd drawer transport sensor (S45) • Sensor check (Perform the input check: 03-[FAX]OFF/[2]/[D])
• Connector check
• Harness check.
4th drawer transport clutch
(CLT11)
• Clutch check (Perform the output check: 03-225)
• Connector check
• Harness check.
LGC board • Connector check (CN328, 350)
• Board check.
Drive unit, Rollers • Gear check
• Roller check
Replace parts Remarks
3rd drawer transport sensor
4th drawer transport clutch
LGC board
Rollers
Classification Error item
Paper transport jam Paper not reaching reverse sensor-2
Check item Measures
Horizontal transport sensor-1(S19) • Sensor check (Perform the input check: 03-[FAX]OFF/[9]/[F])
• Connector check
• Harness check.
Horizontal transport clutch
(CLT2, 3)
• Clutch check (Perform the output check: 03-220 / 221)
• Connector check
• Harness check.
LGC board • Connector check (CN334, 335)
• Board check.
Drive unit, Rollers • Gear check
• Roller check
Replace parts Remarks
Horizontal transport sensor-1
Horizontal transport clutch
LGC board
Rollers