ADD-ON MODULE INSTALLATION ADM Installation procedure:
1-10 IPT Installation Manual Feb,, 2015
attached, that cable runs from the first ADM “OUT” connector to the
second ADM “IN” connector. Refer to Figure 1-4.
4. Plug in the IP5000-series telephone power cord if using a local power
supply. Plug in the LAN cable.
Figure 1-4 IP5000-Series ADM Connection
IP5000-series TelephoneADMADM
ADM connection bracket
ADM cable
ADM cable is routed under the clips
Allow equal service loops on both ends to
allow telephone and ADM angle adjustment.
INOUTIN
Service loops
To Next Page
Loading...
