4 Replacement Procedures 4.25 Touch pad
4.25 Touch pad
Removing the Touch pad
To removing the touch pad, follow the steps below and refer to Figure 4-47.
1. Remove the following screws securing the touch pad assembly from the back.
• M2.5×4B FLAT HEAD screw ×2
2. Remove the touch pad cover while releasing the latches.
3. Remove the touch pad assembly from the slot.
Touch pad cover
Glass tape
Touch pad
assembly
Touch pad cable
M2.5x4B FLAT HEAD
Latches
Figure 4-47 Removing the touch pad assembly
4. Turn the touch pad face down and peel off the glass tape on the connector of touch
pad cable.
5. Disconnect the touch pad cable from the connector on the touch pad.
4-66 [CONFIDENTIAL] TECRA M5 Maintenance Manual (960-542)
To Next Page
Loading...
Need help?
General