67
◆ Address setting procedure 2
1
Set a system address for each system using SW 13 and 14 on the interface P.C. board on the
header outdoor unit of each system.
(Factory default: Address 1)
NOTE
Be sure to set a unique address on each system. Do not use a same address as another system (refrigerant line)
or a custom side.
Interface P.C. board on the header outdoor unit
Line address switches on the outdoor interface PC board (
{: switch on, ✕: switch off)
(Example) Controlling 2 or more refrigerant lines as a group
System wiring
diagram
Outdoor
Indoor
Indoor
Indoor
Indoor
Outdoor
Remote
control
(Group control)
Not used for setup of line address (do not change setup.)
Line
address
Line
address
To Next Page
Loading...
