3
Inverter assembly
WARNING
Wear a pair of gloves.
Otherwise, you will risk an injury involving a
replacement part or some other object.
1. Detachment
1)Stop the air conditioner operation, and turn off
the circuit breaker.
2)Remove the inverter cover.
(M4 × 0.4" (10mm), 2 pcs.)
3)Remove the wiring.
(e.g. the power supply wire, compressor leads,
coils, sensors and heaters)
6) Disengage the hook by gently pressing down the
locking lever with your finger.
(The lower part of the box moves forward.)
skrameRerudecorp kroWdecalper eb ot traP.oN
− 240 −
4) Remove the wire guard.
(M4 x 0.4" (10mm), 1 pc.)
5) Remove the screws securing the box.
(M5 × 0.4" (10mm), 1 pc. each for top and bottom)
Fan IPDU board
072 type
4) Wire guard
4) Screw
Locking lever
072 type
5) Screw
5) Screw with
arrow mark
(2 locations)
To Next Page
Loading...
