[RBM-Y0614FUL]
For the leads of the coil (3pcs) that has the faston terminal of the straight type on the edge(Sleeve : colorless),
connect each of them to any of the tab on the upper side of the TERMINAL (TB02)(4 places).
For the leads of the coil (2pcs) that has the faston terminal of the straight type on the edge(Sleeve : green),
connect each of them to any of the tab on the under side of the TERMINAL (TB02)(4 places).
(Refer to fig.B) For the leads of the coil (6pcs) that has the faston terminal of the flag type on the edge (one side)
and the lead (1pc) that has the faston terminal of the flag type on the both ends, connect them to the TERMINAL
(TB01). (Refer to fig.B) For the connection direction to the TERMINAL (TB01) for the lead that has the faston
terminal of the flag type , refer to the figure B.
[RBM-Y0964FUL]
For the leads of the coil (4pcs) that has the faston terminal of the straight type on the edge(sleeve : colorless ),
connect each of them to any of the tab on the upper side of the TERMINAL (TB02)(4 places).
For the leads of the coil (3pcs) that has the faston terminal of the straight type on the edge(sleeve : green),
connect each of them to any of the tab on the under side of the TERMINAL (TB02)(4 places).
(Refer to fig.C) For the leads of the coil (6pcs) that has the faston terminal of the flag type on the edge (one side)
and the lead (2pcs) that has the faston terminal of the flag type on the both ends, connect them to the
TERMINAL (TB01-1 and TB01-2). (Refer to fig.C) For the connection direction to the TERMINAL (TB01-1
and TB01-2) for the lead that has the faston terminal of the flag type , refer to the figure C.
Flag-Shape
(both ends)
Flag-Shape
(one side)
To Next Page
Loading...
