– 162 –
7-7-11. Monitor Function of Remote Controller Switch
When using a remote controller with the model name RBC-AMT32E, the following
monitor functions can be used.
Calling of display screen
<Content>
The sensor temperature or operation status of the remote controller, indoor unit, or the outdoor unit can be known
by calling up the service monitor mode from the remote controller.
[Procedure]
1 Push + buttons simultaneously for 4 seconds or more
to call up the service monitor mode.
The service monitor goes on, and temperature of the CODE No. 00
is firstly displayed.
2 Push the temperature setup buttons to select the
CODE No. to be monitored.
For displayed codes, refer to the table next page.
3 Push button to determine the item to be monitored.
Then monitor the sensor temperature or operation status of indoor
unit and the outdoor unit in the corresponding refrigerant line.
4 Pushing button returns the display to the normal display.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
14
2
3
To Next Page
Loading...
Need help?
General
