4 Replacement Procedures 4.6
SD/HDD and Fan
4.6 SSD/HDD and Fan
Removing the SSD/HDD and Fan
CAUTION: Do not press on the top or bottom of the drive.
Applying such pressure can either corrupt the data in the drive or
damage the drive.
Remove the SSD/HDD (hard disk drive) and Fan according to the following procedures and
Figures 4-12, 4-13 , 4-14.
1. Remove the two M2.5 x 4 flat-head screws on the SSD/HDD pack.
2. Remove the SSD/HDD pack by pulling on the tab attached to the pack.
3. Remove one M2.5 x 7 black flat-head screw on the Fan.
4. Disconnect the Fan cable form CN9.
5. Remove Fan.
M2.5x4blackflat-head screw
M2.5X7blackflat-headscrew
CN9
Figure 4-12 Removing the HDD pack
NOTE: Do not disassemble the HDD pack when it is working normally.
Disassemble or replace the HDD pack only if it fails.
4-24 TOSHIBA NB100 Maintenance Manual
To Next Page
Loading...
