4.11 Touch Pad Board 4 Replacement Procedures
TOSHIBA NB100 Maintenance Manual 4-39
Installing the Touch Pad Board
Install the touch pad board according to the following procedures and Figure 4-22.
1. Seat the touch pad finger in the correct position and secure it with one M2 x 2.5 black
flat-head screw.
2. Seat the touch pad board in the correct position and secure it with the two M2 x 4
black flat-head screws.
3. Connect the button board flat cables to CN507 and CN 508 on the button board.
To Next Page
Loading...
