6F8C1370
6. Checking the Warning Label on the Main Body
Check that warning label is attached on the main body.
If the label is missing or hard to read due to stain, contact our service department.
[Warning symbols on the nv series main body]
This symbol is a warning symbol for dangerous parts. It is attached on plac
es
where there is a risk of an electric shock or a risk of damage to the main body
due to wrong wiring.
Note the following where this symbol is present.
● Touching the power input terminal of the power supply module while the power is on
causes an electric shock and is very dangerous.
Do not touch the power input terminal.
● For safety, turn off the power before wiring or performing maintenance and
inspection.
● Wire the power input terminal correctly, and avoid applying any voltage exceeding
the specified voltage range. It may cause failure or damage.
● Perform connector connection of the nV-Tool port after turning off the power of the
nV-Tool (such as the PC).
Turn on the power of the nV-Tool after connection.
Be careful not to short-circuit the connector pins with the connector cover.
[Warning stickers]
The warning sticker as shown in the
left figure is attached to the power
terminal of the nv series (except for
power supplies below 24V).
Remove the sticker from the mount,
and attach it on the main body of the
nv series, or on a location near the nv
series where it can be seen easily.
There are stickers in both Japanese
and English. Use the one that suits
your need.
When wiring, remove the sticker
mount.
If the sticker is damaged, contact
you
r distributor.
To Next Page
Loading...
