Toshiba Portege R500 - Page 248

4 Replacement Procedures 4.14 HDD/SSD
4.14.1 2.5” HDD
Removing the 2.5” HDD
To remove the 2.5”HDD, follow the steps below and refer to Figure 4-17.
1. Lift up the 2.5” HDD in the direction of the arrow in the figure below.
2. Disconnect the 2.5” HDD cable from the connector on the 2.5” HDD.
Connector of the
2.5” HDD
2.5” HDD
2.5” HDD cable
Guide x4
Figure 4-17 Removing the 2.5” HDD
Installing the 2.5” HDD
To install the 2.5” HDD, follow the steps below and refer to Figure 4-17.
1. Connect the 2.5” HDD cable to the connector on the 2.5” HDD.
2. Set the 2.5” HDD into the guides of the slot.
4-32 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)