4.14 HDD/SSD 4 Replacement Procedures
4.14.2 1.8” HDD
Removing the 1.8” HDD
To remove the 1.8” HDD, follow the steps below and refer to Figure 4-18.
1. Turn over the 1.8” HDD in the direction of the arrow in the figure below and remove
four cushions from the 1.8” HDD.
2. Disconnect the 1.8” HDD cable from the connector on the 1.8” HDD.
CAUTION: The 1.8-inch HDD cable and SSD cable are the same.
Connector of the 1.8” HDD
Figure 4-18 Removing the 1.8” HDD
1.8” HDD
1.8” HDD cable
Guide x4
Cushion x4
PORTÉGÉ R500 Maintenance Manual (960-634) [CONFIDENTIAL] 4-33
To Next Page
Loading...
