4.22 Touch pad/Fingerprint sensor board 4 Replacement Procedures
PORTÉGÉ R700 Maintenance Manual (960-833) [CONFIDENTIAL] 4-65
6. Peel off the aluminum tape (AL TAPE) and peel off the fingerprint sensor board.
7. Remove the following screws and T-PAD board.
• M2×4C S-THIN HEAD ×2
NOTE: Do not reuse the removed fingerprint sensor board. Be sure to use a new
fingerprint sensor board.
Figure 4-41 Removing the touch pad/fingerprint sensor board (3)
Fingerprint sensor board
T-PAD board
Aluminum tape
M2x4C S-THIN HEAD
M2x4C S-THIN HEAD
To Next Page
Loading...
