Toshiba Q9+ - Page 269

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 257
Table 12. Output Terminal Assignments, My Function Input Setting Assignments, and Parameter/Input Setting
Numbers for the FLA/B/C, O1A/O1B (OUT1), O2A/O2B (OUT2), OUT3 – OUT6, and R1 – R4.
Discrete Output Terminal Assignment Selections
Input
Setting
Param.
Setting
Function
Input
Setting
Param.
Setting
Function
1000 0
Lower-Limit Frequency
1096 96
Specified Data Output 3
1002 2
Upper-Limit Frequency
1098 98
Specified Data Output 4
1004 4
Low-Speed Signal
1100 100
Specified Data Output 5
1006 6
Acceleration/Deceleration Completion
1102 102
Specified Data Output 6
1008 8
Speed Reach Signal
1104 104
Specified Data Output 7
1010 10
Failure FL (All Trips)
1106 106
Light Load Detected
1012 12
Failure FL (Except EF, OCL, EPHO,
and OL2)
1108 108
Heavy Load Detected
1014 14
Over-Current (OC) Alarm
1110 110
Positive Torque Limit
1016 16
ASD Overload (OL1) Alarm
1112 112
Negative Torque Limit
1018 18
Motor Overload (OL2) Alarm
1114 114
External Rush Suppression Relay Acti-
vated
1020 20
Over-Heat Alarm
1118 118
Completion of Stop Positioning
1022 22
Over-Voltage Alarm
1120 120
L-STOP
1024 24
Main Circuit (MOFF) Under-Voltage
Alarm
1122 122
Power Failure Synchronized Operation
1026 26
Low-Current Alarm
1124 124
Traverse in Progress
1028 28
Over-Torque Alarm
1126 126
Traverse Deceleration Active
1030 30
DBR Overload Alarm (not used)
1128 128
Part Replacement Alarm
1032 32
Emergency Off Active
1130 130
Over-Torque Alarm
1034 34
Retry Active
1132 132
Frequency Command ½ Selection
1038 38
PID Deviation Limit
1134 134
Failure FL (Except Emergency Off)
1040 40
Run/Stop
1136 136
External Device 1
1042 42
Serious Failure (OCA, OCL, EF, Phase
Failure)
1138 138
External Device 2
1044 44
Light Failure (OL, OC1, 2, 3, or OP)
1140 140
External Device 3
1046 46
Commercial Power/ASD Switching Out-
put 1
1142 142
External Device 4
1048 48
Commercial Power/ASD Switching Out-
put 2
1144 144
External Device 5
1050 50
Cooling Fan On/Off
1146 146
External Device 6
1052 52
Jogging Operation Active (Jog Run
Active)
1148 148
Sealing Water
1054 54
EOI Keypad/Terminal Board Operation
Switching
1150 150
NPSH/No Flow Alarm
1056 56
Cumulative Run-Time Alarm
1154 154
TBA Active
1058 58
ProfiBus/DeviceNet/CC-Link Communi-
cation Error
1156 156
TBA Alarm Float
1060 60
Forward/Reverse Switching
1158 158
Local/Remote Switching
1062 62
Ready for Operation 1
1160 160
Forced Operation (RUN)
1064 64
Ready for Operation 2
1162 162
Forced Operation (Fire Speed)
1066 66 POFF Alarm 1164 164
Under-Torque Detection
1070 70 Alarm Status Active 1166 166
Frequency Command From (RR/S4)