Program Menu Navigation
Q9 Plus ASD Install/Op Manual
46 https://www.toshiba.com/tic/
UTILITIES
Utilities
Version EOI / ASD Type / CPU Level / EEPROM / MC Level
N/A
Standard Start Up Wizard
See Standard Startup Wizard Requirements on pg.
30.
N/A
Prohibition
Local/Remote Key Command Override
N/A
Local/Remote Key Frequency Override
Show Uninitialized Parameters at Changed From
Default Screen
Alarm Prohibition
(prohibits an EOI alarm
display ONLY — alarm still
activated)
Over-Current Alarm
N/A
ASD Overload Alarm
Motor Overload Alarm
Over-Heat Alarm
Over-Voltage Alarm
Main Power Under-Voltage Alarm
Reserved (POFF) Alarm
Under-Current Alarm
Pre (Approaching) Over-Torque Alarm (Threshold)
DBR (Dynamic Braking Resistor) Overload Alarm
Cumulative Run Timer Alarm
DeviceNet/Profibus/CC-Link Alarm
RS485 Communication
Main Power Under-Voltage Alarm
Stop After Instantaneous Power-Off Alarm
Stop After Lower-Limit Continuous Time
Light-Load Alarm
Heavy-Load Alarm
Maintenance Timer Alarm
Over-Torque Alarm
Soft Stall Alarm
Low Suction/No-Flow Cut Off Alarm
Time-Based Alternation Alarm Float Active
Program Mode Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number
Prohibited
To Next Page
Loading...
