No.
Part name Procedures
Remarks
5
Side cabinet
1. Side cabinet (right)
1) Perform step 1 in 2 and all the steps in 3.
2) Remove the fixing screw (ST2TØ4 × 10L
4 pcs.) used for securing the side cabinet
to the bottom plate and valve fixing panel
2. Side cabinet (left)
1) Perform step 1 in 2.
2)
3)
Remove the fixing screw (ST2TØ4 × 10L
1 pc.) used to secure the side cabinet (left)
on to the heat exchanger.
Remove the fixing screw (ST2TØ4 × 10L
2 pcs.) used for securing the side cabinet
to the bottom plate and heat exchanger.
6
Fan motor
1) Perform work of item 1 of 1 and 2.
2) Remove the flange nut fi
xing the fan motor and
the propeller.
• Flange nut is loosened by turning clockwise.
(To tighten the flange nut, turning
counterclockwise.)
3) Remove the propeller fan.
4) Disconnect the connector for fan motor from
the inverter.
5) Remove the fixing screws (4 pcs.) holding by
hands so that the fan motor does not fall.
* Precautions when assembling the fan motor
Tighten the flange nut using a tightening
torque of 4.9 N•m.
Detail A Detail B Detail C
Propeller fan
Fan motor
Flange nut
B
C
A
(B)
Claw of the
bottom plate
(C)
Claw of the
bottom plate
(A)
Claw of the
bottom plate
To Next Page
Loading...
