10. INSTALLATION PROCEDURE
10-1. Installation Diagram of Indoor and Outdoor Units
2
3
Right
Rear right
Bottom right
Rear left
Bottom left
Left
Insulate the refrigerant pipes
separately with insulation, not
together.
8 mm thick heat resisting
polyethylene foam
1
Batteries
8
Flat head
wood screw
4
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Wireless remote control
Saddle
Extension drain hose
(Not available, provided
by installer)
Shield pipe
Air f lter
Installation plate
600 mm or more
100 mm or more
600 mm or more
600 mm or more
In case of right or left piping
Cut dot-line area
Do not allow the drain hose to get
slack.
Make sure to run the drain hose
sloped downward.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Cut the piping
hole sloped
slightly.
CAUTION
Install in rooms that are 13 m³ or larger.
If a leak of refrigerator gas occurs
inside the room, an oxygen def ciency
can occur.
5
Filter
70 mm or more
50 mm or more
50 mm or more
6
Filter
7
Mounting screw
9
Insulation sheet
100 mm or more
A
C
L
• Loading Batteries
1.
2.
Remove the battery cover.
Insert 2 new batteries (AAA type)
following the (+) and (–) positions.
Before installing the wireless remote controller
3 Batteries
2 Wireless remote controller
To Next Page
Loading...
