2. AUTOMATIC OPERATION
To automatically select cooling, heating, or fan only operation.
1.
2.
PressPress
PressPress
3.
Press
Press
: Select Auto A.
: Select the desired temperature : Min 17°C, Max 30°C
: Select AUTO, LOW , LOW+ , MED , MED+
, HIGH or Quiet
button to change Fireplace1, Fireplace2 and 8°C operation
3.
8°C OPERATION
1.1.1. PPress
2.2. PrePress
to adjust setting temperature from 5°C to 13°C
Note1 : 8°C will operate in Heating mode only. If Air conditioner performs in cooling
operation (including automatic cooling) or dry operation it will change to
heating operation.
5. DRY OPERATION (COOLING ONLY)
For dehumidification, a moderate cooling performance is controlled automatically.
1.1.. PrePress
2.
Pre
ss
: Select Dry
: Set the desired temperature.
4.
COOLING / HEATING / FAN ONLY OPERATION
1. PressPress
2.
PressPress
: Select Cool , Heat , or Fan only
: Set the desired temperature : Min 17°C, Max 30°C
3.
or Quiet
Fan Only : No temperature indication
Press : Select AUTO, LOW , LOW+ , MED , MED+ HIGH
Note :
QUIET is u
ltra
low fan speed for quiet operation.
Note2 : With Fireplace operation on heating mode indoor unit always runs
and cold air breezing might be occurred.
6. Hi-POWER OPERATION
To automatically control room temperature and airflow for faster cooling or heating operation (except
in DRY and FAN ONLY mode)
PressPress : Start and stop the operation
7. ECO OPERATION
To automatically control room temperature to save energy (except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1 degree/
hour for 2 hours (maximum 2 degrees increase). For heating operation the
set temperature will decrease.
FIREPLACE and 8°C operation.
Normal
operation
8°C
Fireplace#1
Fireplace#2
Note: DRY mode fan speed is set to Auto only.
To Next Page
Loading...
