12. POWER-SELECTION OPERATION / SILENT OPERATION
11. QUIET OPERATION
To operate at ultra low fan speed for quiet operation (except in DRY mode)
Press [ ] Button : Start and stop the operation.
Note: Under certain conditions, QUIET operation may not provide adequate
cooling or heating due to low sound features.
POWER-SELECTION AND SILENT OPERATION
[100%]
SILENT#2 SILENT#1
[75%] [50%]
13. COMFORT SLEEP OPERATION
To save energy while sleeping, automatically control air flow and automatically turn OFF.
Press : Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: The cooling operation, the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase). For heating operation,
the set temperature will decrease.
Note1 : When the level is selected, POWER-SEL level flashes on remote LCD display for 3 seconds
In case of 75% and 50% level, number “75” or “50” also flashes for 2 seconds.
Note2 : Due to the reason that POWER SELECTION FUNCTION and silent operation,
inadequate cooling or heating capacity may occur.
Press button to select Power-SEL, Silent 1 and Silent 2
10. PRESET OPERATION
Set your preferred operation for future use. The setting will be memorized by the
unit for future operation (except air flow direction).
1. Select your preferred operation.
for 3 seconds to memorize the setting. The
P
mark
2. Press and ho
ld
displays.
3.
Press : Operate the preset operation.
14. FLOOR WARMING OPERATION
Heating will operate with downward blowing only. Temperature of air outlet will be higher than usual.
Press
: Start and stop the operation.
Note: FLOOR operation can active in Heat mode only.
To Next Page
Loading...
