(Front view)
800 or more
670 or more
Partition board
Opening for receiver
50 or more
70 or more
50 or more
500 140
(Side view)
Partition board
20 to 30
Opening for receiver
• Gripe the air grille inlet by two hands at the handle positions.
• Pull the air inlet grille as the arrow direction.
Air inlet grille
Hook of front panel
Rope
Heat insulation block
• Completely fill pipe by heat insulation block to protect water dew.
• Heat insulation block can cut to an appropriate size and use.
10-3-5. How to open the air inlet grille
• The rope at the backside of air inlet grille is using for handle it on the front panel
when you need to clean up the air filter.
10-3-6. How to use the heat insulation block
4. In case of lattice establishment
• Follow the following fi gure, make sure to keep enough distance
between lattice, frame and wall.
• Be sure to switch to wall burying mode.
• The lattice should be make of wood.
• Between the air inlet and outlet, should be devided with partition board.
• Be sure to establish the open part for RECEIVER.
• The open part of lattice must be opens 70 % or more of the wall hole.
• The open part of lattice must be arranged uniformly.
(Top view)
Partition board
(Unit : mm)
To Next Page
Loading...
