–21–
Owner’s Manual
While setting the functions.
When the central control is used (when the run and stop operation is prohibited).
• The Schedule timer cannot be set on the Follower remote controller when the dual remote controller system is used.
• Adjust the clock before setting the Schedule timer. (page 25)
• The time can be adjusted by the minute.
• The temperature can be set within the range from 17°C to 30°C. (The limited temperature range is applied if the set
temp range limit function is activated.)
• Push the [ CANCEL] button to stop the setting procedure. No setting has been made and the screen returns to
the “Schedule timer” screen.
• The operation mode for the Schedule timer is the mode selected last time when the air conditioning unit was used.
Condition setting
* Up to 8 different running patterns per day can be programmed.
1 Push the [ ∧] / [ ∨] button to select
“2. Condition setting” on the “Schedule
timer” screen.
2 Push the “ Set” [ F2] button.
The current setting appears.
Push the “ Day” [ F1] button to
confirm the settings for each day.
Push the “
Next” [ F2] to confirm
the current settings. 8 different settings
appears.
3 Push the [ MENU] button.
4 Push the [ ∧] / [ ∨] button to select
the day to set, then push the “ ↓”
[
F1] button.
5 Push the [ ∧] / [ ∨] button to select
“--”, “ON”, “OFF”
Select “ON” to change the operation start time
and the set temperature settings.
Select “OFF” to change the operation stop time
setting.
“--” indicates that the item has not been set.
6 Push “ →” [ F2] to select time
or temperature.
When “--” is displayed, time or temperature
cannot be selected for that item.
7 Push the [ ∧] / [ ∨] button to set
time or temperature.
To Next Page
Loading...
