41
EN
Introduction Connections Basic Setup Playback
Editing
Others
Function Setup
Recording
5 Select the channel number to record
using [U \ D], then press [P].
To record from the external input, select “AV1”,
“AV2”, or “AV3”.
6 Select the recording media (“HDD”
or “DVD”) using [U \ D], then press
[P].
7 Select the recording mode using
[U \ D], then press [P].
Refer to “Recording Mode” on page 33.
8 For DVB channel recording:
Select “STTL” to “ON” or “OFF”
using [U \ D].
If you set “STTL” to “ON”, subtitle will be recorded
too.
• When analogue channel is selected, “PDC” will
be displayed instead of “STTL”.
For analogue channel recording:
Select “PDC” to “ON” or “OFF”
using [U \ D].
Refer to “PDC (Programme Delivery Control)” on
page 42.
• When DVB channel is selected, “STTL” will be
displayed instead of “PDC”.
• PDC system is only available for HDD.
• PDC system is not available for periodical timer
programme.
9 Press [ENTER/OK] when all
information required is entered.
Your programme setting is stored.
• To set another programme, repeat steps
2 to 9.
• To exit, press [TIMER PROG.].
• When 2 or more programmes are overlapped,
“Timer program overlapped” appears, and the
overlapped program will be displayed in blue. To
correct the timer programme, refer to “Checking,
Cancelling or Correcting the Timer
Programming Information” on page 42.
The icon will appear on the front panel display.
Note
• If you have not set the clock, the clock setting
window will appear instead of the Timer
Programming list. Continue from step
4 in “Manual
Clock Setting” on page 32 before programming the
timer.
•Press [L \ P] to move the cursor in the Timer
Programming list.
• If you have a timer programme with PDC function,
and if you are watching different channel from the
timer programme, confirmation message to change
the channel will appear 15 minutes before the
program starts (the message will also re-appear 30
seconds before the program starts). The channel
will automatically be changed to the programmed
channel 15 seconds before the programme starts.
Alternate recording (DVD only)...
If there is no recordable disc in the unit, if the disc
does not have enough space to complete the
recording, or if the material is “copy-once” programme
and prohibited to be recorded on a DVD, the unit will
detect it and automatically record to the HDD even
when DVD is selected as the recording media. If the
available space on the HDD is less than that of DVD,
the unit will not perform the alternate recording. This
feature is available only for timer recording. Not
available for one-touch timer recording.
Timer Programming
1/1
Date
06/12
07/12
07/12
Start
7:00
9:00
17:00
End
9:00
9:30
18:00
CH
18
190
901
New Program
0:00 THU 06/12
STTL
PDC
E2J70BD_EN.book Page 41 Friday, June 29, 2007 2:50 PM
To Next Page
Loading...
