Toshiba Satellite A40 Series User Manual

3 Tests and Diagnostics 3.28 IEEE1394 test program
3.28 IEEE1394 test program
This section describes how to perform the IEEE1394 test with the test program.
NOTE:
Use another computer that can communicate by IEEE1394 (i. Link) cable as a
reference machine to perform this test.
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
Insert the Diagnostics disk in the floppy disk drive and turn on the computer.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu will appear:
********************************************************************
* IEEE1394 [XXXXX] test menu ( For Repair ) V1.00 *
********************************************************************
* *
* 1 ....IEEE1394 test *
* *
* 2 ....Responder tool *
* *
* 3 ....ID Check *
* *
********************************************************************
.... Press test number[1-3] ?
To execute the TEST, select the test number you want to execute and press Enter.
Subtest 01 IEEE1394 test
Specifies the data size and transfer speed between the responder connected
with a responding cable, and sends and receives data. A dedicated cable for
I-link is necessary.
Subtest 02 Responder tool
This program initializes the machine responder.
Subtest 03 ID Check
This program displays the GUID.
3-80 Satellite A40 Maintenance Manual (960-458)

Toshiba Satellite A40 Series Specifications

General

Brand	Toshiba
Model	Satellite A40 Series
Category	Laptop
Language	English