4 Replacement Procedures 4.16 Sound board
4.16 Sound board
Removing the Sound board
To remove the sound board, follow the steps below and refer to figure 4-25.
1. Disconnect the sound board I/F cable from the connector PJ9550 on the system
board and from the connector on the sound board.
2. Remove the following screws securing the sound board.
• M2.5×6B FLAT HEAD screw ×2
3. Remove the sound board.
M2.5
6B FLAT HEAD
Sound board I/F cable
Sound board
PJ9550
Figure 4-25 Removing the sound board
4-44 Satellite A40 Maintenance Manual (960-458)
To Next Page
Loading...
