4 Replacement Procedures 4.17 System board/ Bat con cover
4.17 System board/ Bat con cover
Removing the System board/Bat con cover
To remove the system board/bat con cover, follow the steps below and refer to figures 4-26
and 4-27.
1. Remove the following screw and bat con cover.
• M2.5×6B FLAT HEAD screw ×1
M2.5
×
6B FLAT HEAD
Bat con cover
Figure 4-26 Removing the bat con cover
4-46 Satellite A40 Maintenance Manual (960-458)
To Next Page
Loading...
