4.23 Display mask/LCD unit/FL inverter 4 Replacement Procedures
4.23 Display mask/LCD unit/FL inverter
Removing the Display mask/LCD unit/FL inverter
The following describes the procedure for removing the display mask, LCD unit and FL
inverter (See Figure 4-35 to 4-37).
1. Peel off two mask seals and remove the following screws.
• M2.5×6B FLAT HEAD screw x2
2. Insert your finger between the upper edge of the display mask and the LCD, and
remove the display mask while unlatching the display mask.
M2.5
×
6B FLAT HEAD
Mask seal
Display mask
LCD
Figure 4-35 Removing the display mask
Satellite A40 Maintenance Manual (960-458) 4-57
To Next Page
Loading...
