4 Replacement Procedures 4.10 Wireless LAN board/Modem Daughter Card
Installing the Modem Daughter Card
To install the modem daughter card, follow the steps below and refer to figures 4-17.
1. Connect the modem cable to the connector on the modem daughter card.
2. Connect the modem daughter card to the connector PJ3000 on the system board.
CAUTION: Be careful not to damage the card and connector.
3. Secure the modem daughter card with the following screws.
• M2×4Z BIND screw ×2
4-32 Satellite A40 Maintenance Manual (960-458)
To Next Page
Loading...
