4 Replacement Procedures 4.24 LCD cable/Sensor switch/Wireless LAN antenna
3. Remove the hinge cap (at the LCD cable side).
4. Pull out the LCD cable from the hole.
5. Remove the sensor switch while unhooking the latches.
Hinge cap
Sensor switch
Figure 4-40 Removing the hinge cap (on the LCD cable side) and sensor switch
6. Peel off the acetate tape on the back and take out the sensor switch cable from the
guide and hole.
cetate tape
cetate tape
Wireless LAN antenna
Sensor switch cable
Figure 4-41 Removing the sensor switch cable
4-62 Satellite A40 Maintenance Manual (960-458)
To Next Page
Loading...
