4.26 Fluorescent lamp 4 Replacement Procedures
4.26.9 Replacing the 15.0 Inch SXGA+ Sharp Fluorescent lamp
CAUTION: When you replace the fluorescent lamp, wear finger covers or gloves to
avoid contaminating or damaging the LCD module. Be careful not to let
dust or other foreign substances into the LCD module.
Disassembling the 15.0-inch SXGA+ Sharp Fluorescent lamp
To disassemble the 15.0 inch SXGA+ Sharp fluorescent lamp, follow the steps below and
refer to Figures 4-129 to 4-138.
1. Turn the LCD module face down, and remove the protection cover S (A), protection
cover G (B), fixing tape (C) and fixing tape for lead wire (D).
NOTE: 1) Be careful not to damage the TCP or chips.
2) Discard the tapes removed. Do not reuse them.
(A) Protection cover S
(C) Fixing tape
(B) Protection cover
(D) Fixing tape for lead wire
Figure 4-129 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (1)
Satellite A40 Maintenance Manual (960-458) 4-133
To Next Page
Loading...
