4.26 Fluorescent lamp 4 Replacement Procedures
4. Turn the LCD module face down. Remove four screws fixing the board and remove
the FPC (G). Open the bent portion of the TCP of the board and remove the backlight.
Screw
Screw
Screw
Screw
(G) FPC
Screw loosening torque: 0.9kg
cm
Open the cap of the connector and
remove the FPC.
Figure 4-132 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (4)
Do not hold the edge. Do not hold the edge.
Raise the board and make this condition.
Figure 4-133 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (5)
Satellite A40 Maintenance Manual (960-458) 4-135
To Next Page
Loading...
