4.26 Fluorescent lamp 4 Replacement Procedures
6. Place the LCD panel (I) on the backlight unit (H).
NOTE: Make sure there is no dust between the LCD panel and backlight unit. If any dust
is found, remove it with crepe tape or others, which has no remaining of paste.
(H) Backlight
unit
(I) LCD panel
Guide rib
Guide rib
Guide rib
Guide rib
Make sure the LCD panel is
installed in the guide rib surely.
Figure 4-145 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (17)
Satellite A40 Maintenance Manual (960-458) 4-143
To Next Page
Loading...
