4 Replacement Procedures 4.26 Fluorescent lamp
4. Turn the LCD module face down and remove the two screws fixing the board. Then
open the bent portion of the TCP of the board and remove the backlight.
Screw
Screw
Screw loosening torque: 1.2kg
cm
Figure 4-101 Replacing 15.0 Inch Sharp fluorescent lamp (XGA) (4)
Do not hold the edge. Do not hold the edge.
Raise the board and make this condition.
Figure 4-102 Replacing 15.0 Inch Sharp fluorescent lamp (XGA) (5)
4-114 Satellite A40 Maintenance Manual (960-458)
To Next Page
Loading...
