Replacement Procedures
Satellite C800 and Satellite L800
Maintenance Manual (960-Q08)
4.12 CPU
Removing the CPU heat sink
The following describes the procedure for removing the CPU heat sink (See Figure 4-12-1 to
4-12-3).
1. Disconnect fan cable from the connector on the system board
2. Remove the following screws securing the heat sink holder along 1 to 3.
3. Remove fan screw.
M2.5x3.0 screw x2
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
4. Remove the CPU heat sink.
Figure 4-12-1 Remove the CPU heat sink
To Next Page
Loading...
