Software Installation
Strata CIX Database Programming
2-12 Strata CIX PC Attendant Console Installation 06/09
Make Station Assignments on CIX
This procedure is for programming a digital station as the attendant console speech path. If you
are setting up an IP attendant console (and do not want a digital station option) skip to
“IP Station
Assignment” on page 2-13.
1. Digital Station Assignment:
a. Select Station > Station Assignments (Program 200), specify the Prime DN for this
particular Attendant Console. The number entered here is the DN used to reach this
specific console.
Do not use 0 as the Prime DN. Dial 0 is set in “Create Dial 0
Destination” on page 18. Do not assign the Attendant Console PDN to another DKT
or station.
b. Enter data for the FBs listed below:
p 01 – Specifies the equipment number (shelf/slot/port) required for assigning a new DN to
the system. Set the CIX Attendant Console DN to the BDKU\BDKS or BWDKU port
(required).
p 02 – Select DKT Station type (required).
p 03 – Select Extension (not Voice Mail).
p 04 – Toshiba recommends entering COS 10 at the following three prompts:
“COS DAY1=10”, “COS DAY2=10” and “COS Night=10” (preferred).
p 11 – Select Dial Tone - selects Dial Tone as the tone heard after LCR access codes are
dialed.
2. Make DKT Data Assignments on CIX
a. Select Station > Station Assignments > DKT Tab (Program 204), enter the Prime DN for
this particular Attendant Console.
3. Enter data listed below:
p 01 – Assign the Station Type as “Attendant” (required).
p 02 – Select 3 to assign the key strip assignments for the Attendant Console (required).
p 05 – Select Tone First signaling (required).
Required Feature Settings
FB Description Setting
01
PDN Equipment Number -Specifies the equipment number (shelf/
slot/port) required for assigning a new DN to the system.
xxyyzz
02
Station Type - to assign the DKT Station type
DKT
03
Circuit Type - assign Extension attributes to ports
Extension
04
COS Day1/Day2/Night - Toshiba recommends entering COS 10
at the following three prompts: “COS DAY1=
10”, “COS
DAY2=
10” and “COS Night=10 (as per programmed in Prog 103)
10/10/10
11
Dialing Progress Tone - assign Dial Tone as the type of tone
heard after LCR access codes are dialed
Dial Tone
All other FBs may be set according to the customer’s preference
To Next Page
Loading...
