Need help?Do you have a question about the Toshiba RSM 100 and is the answer not in the manual?
Details the PC, OS, IE, hard disk, display, keyboard, mouse, CD-ROM, and RS-232C port.
Explains connecting a PC to the relay via an RS-232C cable.
Describes how to start RSM100 and choose on-line or off-line operation.
Details how to extract, display, save, and print fault, event, and disturbance records.
Explains how to extract, display, save, and print record data.
Explains how to extract and display record data (fault, event) in on-line mode.
Explains how to display and print record data from a saved file in off-line mode.
Explains how to view status data for metering, inputs, outputs, elements, time, and counts.
Explains how to view or change relay settings, including password.
Explains how to view or change relay settings after entering a password.
Outlines functions like disabling monitoring, manual testing, and mode change.
Describes how to display waveforms by opening data in the PC control software.
Explains the steps to open and display waveform data from the analysis screen.
Explains how to set parameters for analog elements in the waveform data element table.
Describes how to set parameters for binary elements in the waveform data element table.
Explains how to move cursors for measurement and analysis.
Describes how to move and overlay waveforms.
Describes how to save waveform data, including copying or renaming.
Describes how to print the displayed screen or the waveform itself.
Describes how to set parameters for calculating measurement and analysis values.
Describes how to display measurement values of waveforms.
Describes how to calculate and display fault times.
Describes how to display the analysis values of waveforms.
Describes how to display the vector diagram of the waveform.
To Next Page
General