⎯ 123 ⎯
6 F 2 S 0 7 1 5
■Displaying Frequency
This part describes how to display the frequencies for 4 cycles before and after the active
cursor position.
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Measurement] menu, click [Frequency].
③ The frequencies of the channels are displayed.
･ The frequencies for 4 cycles before and after the cursor position are calculated.
･ You can update the values by moving the cursor.
･ [--------] is displayed in the channel where the value can not be measured.
2-11
To Next Page
Loading...