Toshiba RSM 100 - Selecting Reference Phase

⎯ 115 ⎯
6 F 2 S 0 7 1 5
■Selecting Reference Phase
This part describes how to select the reference phase to measure the phase differences and
display the vector diagram.
《Note for Operation》
● There are 2 type of reference phase: CH reference phase and phase order reference
phase.
The CH reference phase is the channel number of AC element that is the reference
phase to display the measurement values of the waveforms.
The phase order reference phase is the phase order that is the reference phase to
display the analysis values.
《Operating Procedure》
① On the [Measurement] menu, click [Phase Difference].
② On the [Analysis] menu, click [RMS Value].
2-3