⎯ 130 ⎯
6 F 2 S 0 7 1 5
2.3 Displaying Analysis Value of
Waveform
This section describes how to display the analysis values of the waveforms.
■Displaying RMS Value
■Displaying Symmetrical Component
■Displaying Power Value
■Displaying Impedance Value
CAUTION
Although 2 or more analysis values can be displayed at
a time, the screen may freeze while displaying 2 or
more.
In this case, restart the unit (computer).
■Displaying RMS value
This part describes how to display the RMS values for 1 cycle before the active cursor position.
《Note for Operation》
● Select phase order before operating.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Phase Order)
● You can select the primary values or the secondary values for the RMS values.
You can select the leading display or delay display for the phase differences.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Analysis] menu, click [RMS Value].
2-18
To Next Page
Loading...