⎯ 93 ⎯
6 F 2 S 0 7 1 5
1.4 Moving Cursor
This section describes how to move the cursors. The cursors are used to specify the
measurement and analysis points.
《Note for Operation》
● 4 cursors (Cursor 0～3 ) are displayed.
However, when 1 of the 4 cursors is the measurement point for the measurement and
analysis operation, the active cursor is the measurement point.
● The cursor 0 is also the reference of relative time display.
《Operating Procedure》
① On the [Set] menu, point to [Select Cursor], and then click the cursor that you want to
move.
･ The cursor selected by the operation is in the active status(active cursor).
1-17
To Next Page
Loading...