⎯ 12 ⎯
6 F 2 S 0 7 1 5
2.8 Menu Items
The RSM100 software can operate either on-line (i.e. communicating with a relay) or off-line.
The RSM100 software has six menus named Record, Status, Setting, Test, PLC tool and
MIMIC tool. The PLC tool and MIMIC tool are applied to some of relay model.
The Record menu enables the fault, event and disturbance records stored in the relay to be viewed.
The Status menu enables the power system quantities and the status of binary inputs, binary
outputs and measuring elements to be viewed.
The Setting menu enables the settings to be viewed or changed.
The Test menu is used to perform commissioning tests or maintenance tests.
The PLC tool is software used to edit PLC (Programmable Logic Control) function.
The MIMIC tool is software used to edit MIMIC configuration picture.
In the on-line operation, all the menus are accessible but in the off-line operation, the Status menu
and Test menu are inaccessible. In case of remote connection (including Ethernet LAN), however,
Test menu are inaccessible.
Appendix A shows the hierarchy of menu items.
Note: The operation procedure of Waveform data analysis in the Record menu is detailed in
Appendix B.
Note: If “Decimal symbol” of “Regional and language options” in “Control panel” is set to “,”
(Comma), the decimal symbol of electric quantities, numerical values and setting values on
Record, Status and Setting screens is expressed by comma (,). However, a numerical value
for selection item is expressed by period (.) because it is dealt with a character.
To Next Page
Loading...