⎯ 133 ⎯
6 F 2 S 0 7 1 5
■Displaying Power Value
This part describes how to display the power values for 1 cycle before the active cursor position.
《Note for Operation》
● Select phase order before operating.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Phase Order)
● You can select the primary values or the secondary values for the power values.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Analysis] menu, click [Power].
③ The power values of the current phase order setting are displayed.
･ The power values for 1 cycle before the cursor position are calculated.
･ You can update the values by moving the cursor.
･ [--------] is displayed where it can not be analyzed.
2-21
To Next Page
Loading...