Toshiba RSM 100 - Displaying Instantaneous Value

⎯ 119 ⎯
6 F 2 S 0 7 1 5
2.2 Displaying Measurement Value of
Waveform
This section describes how to display the measurement values of the waveforms.
■Displaying Instantaneous Value
■Displaying RMS Value
■Displaying Phase Difference
■Displaying Frequency
■Displaying Harmonics
■Displaying Time between Cursors
■Displaying Relative Time
■Displaying Operating Time of Relay
■Displaying Fault Time
■Displaying List of RMS Value
CAUTION
Although 2 or more measurement values can be
displayed at a time, the screen may freeze while
displaying 2 or more.
In this case, restart the unit (computer).
■Displaying Instantaneous Value
This part describes how to display the instantaneous values at the active cursor position.
《Note for Operation》
● You can select the primary values or the secondary values for the instantaneous
values.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Measurement] menu, click [Instantaneous Value].
2-7