Toshiba RSM 100 - Initial Setting Value

⎯ 147 ⎯
6 F 2 S 0 7 1 5
2.8 Initial Setting Value
Item Initial setting value
・The position of Cursor 0 The fault detection point
・The position of Cursor 1 The lowest voltage point
・The position of Cursor 2 The restoration from fault point
・The position of Cursor 3 0 ms
・The active cursor Cursor 1
・The zooming in ratio of the The size in which 1 sample of the waveforms fits to
time axis the 1 dot of the screen
・The unit of time to display the The elapsed time from the beginning of the
measurement and analysis values waveforms
・The relay operating time No display
・The reference phase (CH) 1 ch
・The reference phase (phase order) Phase A Voltage
・The hard copy mode Monochrome
・The phase difference display Delay display
・The unit of time displayed ms
・The value display The secondary values
・The fault time calculation at the Execute
data reading
2-35