⎯ 137 ⎯
6 F 2 S 0 7 1 5
■Setting Parameters
This part describes how to set the vector diagram, the reference phase and the phase order.
《Note for Operation》
● You need to set the contents to be displayed and the scale in the vector diagram
setting.
《Operating Procedure》
① To set the vector diagram, click [Set], and then click the [Vector Setting].
② Click [Voltage] and [Current] options to select the elements to be displayed in the
vector diagram.
Then, select [Phase Only] or [Phase and Line] to be displayed for each element .
･ The selection of [Phase Only] or [Phase and Line] is ineffective for the symmetrical component display.
③ Click [3-Phase] or [Symmetrical Component].
④ To display the scale of the vector diagram automatically, click [Auto Scale] option to
activate the automatic scale.
2-25
To Next Page
Loading...